10
SETTING CODES USING A MANUAL SEARCH
(only to be performed if the speci
fi
c code
could not be found
)
CHECK
Check that the other buttons correspond to the functions of the original remote control; if not, it is likely
that the code found is incorrect, but is used for a very similar device. In that case, repeat the procedure
from point
2
.
If the manual search for the code is successful, obtain the code in use by following the
DISPLAY CODE IN
USE
procedure and make a note of it inside the battery cover.
NOTE:
During the search the indicator stops
fl
ashing and the remote control exits the programming mode
in the following cases:
• if for 12 seconds the button indicated is not pressed or if another button is pressed
• if the list of codes to
fi
nd is terminated. If this happens, go to the
www.meliconi.com
website
1.
Switch on the device to be programmed:
- if it is a
TV, SAT
or
TER
select a programme
- if it is a
DVD
insert a
DVD
.
- if it is a
VCR
insert a cassette.
2.
Press and hold down for 6 seconds the device selection
button corresponding to the device you wish to enter
the code for.
Note: Use the
PVR
button if the device is a
VCR
.
3.
Release the button. The indicator light will
fl
ash. Point
the remote control at the device and press the
ON/OFF
key (or
PLAY
if it is a
VCR/DVD
). If the device does
NOT
switch off (or if the
VCR/DVD
does not start playing)
press the same button again slowly (it may be necssary
to press the button several times).
4.
When the device responds correctly, press
OK
. Three
long
fl
ashes indicate that the operation has been carried
out
correctly
.
6 SEC.
or
or
or
or
or
ENTERING THE CODE DIRECTLY
(only to be performed if you know the speci
fi
c code to be set)
1.
Press and hold down for 6 seconds the device selection
button corresponding to the device you wish to enter
the code for.
Note: Use the
PVR
button if the device is a
VCR
.
2.
Release the button. The indicator light
fl
ashes
.
Immediately enter the speci
fi
c code previously found.
(e.g.. 1306).
3.
Three long
fl
ashes indicate a correct setting.
If they do not appear, repeat the procedure. If this still does not work it means the code indicated
is not in the remote control, so it must be loaded using the INTERNET as described in the following
section.
6 SEC.
or
or
or
or
