HOW TO PROGRAMME THE REMOTE CONTROL
F I T T I N G T H E BAT T E R I E S
Before programming and using the remote control,
fit the batteries.
The remote control requires 2 new
AAA/LR03
batteries. Insert the batteries as shown:
• Change the batteries if the light indicator starts to flash during use. The batteries are low.
• Make a note of the codes for your appliances on the adhesive label inside the battery cover in case you
have to reprogramme your remote control.
• This remote control has a permanent memory and does not lose the programmed codes or functions
when the batteries are removed.
To display and make a note of the code memorized by means of the search,
follow the instructions described in the paragraph CURRENT CODE DISPLAY.
ADDITIONAL CHECK
Check that some of the other keys, corresponding to those on your original remote control, work correctly.
If the commands function incorrectly or erratically, you have probably entered a code for a similar remote
control but not the right one. In this case, repeat the search procedure starting from
point 3
, entering the
code previously used (e.g. 0025).
1
. Turn on the appliance to be programmed:
- if a
VCR
, insert a cassette
- if a
TV, SAT
or
TER
select a programme
- if a
DVD
insert a DVD.
2
. Look for the brand of the appliance you want to programme
in the code list and make a note of the corresponding
code alongside
(e.g. PHILIPS 0025).
3
. Hold down the selection key for the appliance to be
programmed for 5 seconds.
4
. When the key is released, it will start to flash. Enter the
brand code previously identified
(e.g. 0025). The selection
key flashes more quickly to indicate that the remote
control is ready for the search.
5
. Point the remote control towards the appliance. Press
and slowly release the
ON/OFF
key or
PLAY
for the
VCR
and
DVD
several times,
stopping
when the appliance
responds correctly to the command.
6
. When the appliance responds correctly, press the
OK
key
to confirm. Three flashes indicate that the search operation
has been completed correctly.
The
TV - DVD
-
SAT
keys can be programmed according to your
requirements, following the procedure described below.
The quickest and easiest way to programme the remote control is by consulting enclosed
CD or the website
www.meliconi.com/guide
.
Warning:
programme one appliance at a time!
PHILIPS
0025
or
+
+
+
7
5 SEC.
or
or
VCR
TER
