Calibration Software PTC04
User Manual
Page 7 of 17
REVISION 1.44.01 - 2 MAY 2018
UI_0PTC04AAMLX
If you
don’t use
a Keithley 2000 or Agilent 34401A multi meter, you have to use a high accuracy voltmeter. The
accuracy of the calibration depends on the precision of the voltmeter and the number of digits entered. With a
manual voltmeter, the program will start with calibrating the internal voltmeter which will be used to check the
PTC04 programmer.
Figure 8: Proceed Check?
Press
yes
to continue.
At this stage the software will check if the calibration board and, if selected, the Keithley 2000 or Agilent 34401A
Multimeter are connected. If the calibration board is not detected, a message is shown.
Figure 9: Check setup
If the setup is not complete, press No, switch of the programmer, check your setup and restart the
program.
