Melec ADB-5431, User Manual

Page: 29 / 42

Instructions Manual
１０．Specifications
R1
１０－１．General Specifications
DC+24V
*1 (Ripple voltage P-P 2.0V or less)
● Rated input current : 〔DRIVE I.SEL ⇒ IH set up〕
at DRIVE DC+24V: 1.7A
*2
● Rated input current : 〔HOLD I.ADJ ⇒ Approx. 40％ set up〕
at HOLD DC+24V: 0.5A
●DRIVE CURRENT IL:0.38A/phase(typical)
IH:0.68A/phase(typical)
●HOLD CURRENT Approx. 40% of DRIVE CURRENT
(factory-set)
●DRIVE CURRENT IL:0.75A/phase(typical)
IH:1.35A/phase(typical)
●HOLD CURRENT Approx. 40% of DRIVE CURRENT
(factory-set)
●Drive pulse input (CW, CCW) Photo-coupler input
●Motor excitation stop input (M.F) Photo-coupler input
●Phase signal output (P.O) O/C output
●Motor selection (MOTOR SEL)
●HOLD CURRENT adjustment (HOLD I.ADJ)
●DRIVE CURRENT selection (DRIVE I.SEL)
●Step angle selection (STEP SEL)
●HOLD switching time selection (DHT SEL)
●ROTATE CHARACTERISTIC selection (R.C SEL)
●PULSE INPUT TYPE selection (SPI SEL)
Indoor (Exposure to direct sun is not allowed.)
Without any corrosive or inflammable gas, oil mist, or dust.
*1
Input voltage range is DC+24V±10%.
*2
Use a power supply that provides sufficient input current.
Operating Ambient
Temperature
0℃ ～ +40℃ (No freezing allowed.)
Supply Power
Motor output
current
Input Signal
Output Signal
MOTOR SEL switch
is set to〔5L〕
MOTOR SEL switch
is set to〔10L〕
Overheat alarm
(No condensation allowed.)
Storing Temperature -10℃ ～ +55℃ (No freezing allowed.)
Weight 0.15 kg
Withstanding
Vibration
No abnormality should be found after a vibration test
at 10～55Hz, 0.15mm P-P
Insulation resistance
DC connector - signal connector - Frame
(Each other)
DC500V 100MΩ or more
●Overheat alarm LED (O.H.A LED)
Functions of
Operating Sections
Exterior Dimensions
Ｈ
66 ×
Ｗ
71 ×
Ｄ
34 (mm)
Storing Humidity 80％RH or less (No condensation allowed.)
Atmosphere
Operating Ambient
Humidity
80％RH or less
-29-