17
Assembly of the squeezing rubber pad
After the squeezing rubber pad is pulled out for cleaning, insert it back as indicated in the
picture below.
Bottom of the
squeezing cup
Insert the rubber pad in the direc-
tion shown in the picture above
Insert it tight.
Turn on the switch (forward)
Forward: Push fruit/vegetables downwards for
squeezing.
Reverse: Fruit/vegetables return upwards
Note: Don’t press the switch with wet hands.
Don’t let the unit run empty so as not to cause
damage.
Wash the fruit/vegetables. If their sizes are larger
than that of the feed inlet, cut them into blocks
with proper size. Put the fruit/vegetables into the
feed inlet and push inwards with the pushing rod.
Note: Use fresh fruit/vegetables. Fruit/vegetables
that have been stored in a refrigerator for a long
time should first be immersed in cold water for
over 10min.
*Always remove kernels.
If the juicer stops suddenly during operation, press
the “stop” button first, and then press the “reverse”
button to push the fruit/vegetables in the spiral
propeller upwards.
Press the “forward” button again (repeat the pro-
cess about 3 times).
*During the “reverse” phase press the cover
slightly with your hands.
*Unless the appliance runs properly after the
aforesaid operation, disassemble the squee-
zing cup for cleaning, and then start squee-
zing again.
*Hard vegetables (such as carrots) should first
be cut into strips so as not to cause clamping
or even product damage.
The appliance has not been designed to crush
grains (motor clamp and mechanical failure are
likely).
Pushing rod
Feed inlet
