15
8
9
10
11
12
APPLE
Open up “Settings” on your iOS device and select “Wi-Fi” and let it search for a network.
The network will be “Wi-Fi-cam-p2p”. Select “Wi-Fi-cam-p2p” to connect.
Now, open the “uCare Cam” app and select the tab at the bottom of the screen that says
“Wi-Fi Connect”.
Select “Router mode”, then “Next”. Enter here the Wi-Fi network name (SSID) and password of
your home router.
After the IP camera receives this information, it will restart. Please wait for it to start up and con-
nect to your Wi-Fi router. When it successfully connects, the status LED colour will turn orange.
It may take up to 5 minutes.
Then select the camera name in the “uCare Cam” app to connect.
Note: If the status LED colour does not turn orange, please check your Wi-Fi router and make
sure the IP camera is within the signal area of your Wi-Fi router. Then try this setup again.
Set the IP camera to connect to the Wi-Fi router
1
2
3
Setup Wi-Fi - WPS mode
Enter WPS mode
Programme Loading
Open the “uCare Cam” app
Power on your IP camera.
The status LED on the IP camera will be green for about 15 seconds.
The status LED will flash red for about 15 seconds.
Select the tab:
then select the tab:
to enter Step 2 (see Figure 8).
and select “Wi-Fi Setting” or “Wi-Fi Connect” at the bottom of the screen.
If your Wi-Fi router has a WPS (Wi-Fi Protected Setup) button, you can use it to set up the IP camera.
(Must enable WPA/WPA2 encryption in Router). On the Wi-Fi router, you will see a button labelled “WPS”.
It may also be called “QSS” or “AOSS”.
Install your IP camera by WPS connection mode