f
Be particularly careful when carrying
out a „plunge cut“ into an existing
wall or an area you can‘t see into.
The plunging cutting wheel may hit
gas or water pipes, electrical cables or
other objects and cause kick back.
CAUTION! A spindle lock is
located on the upper side of the
unit. Never press the spindle lock
while the grinding body is rotating.
ATTENTION! Only use reinforced
grinding wheels and cup wheels.
Handling, transportation and storage
of grinding discs:
Grinding discs are fragile and sensitive
to impacts and bumps. For this reason,
special care must be taken:
a) Never drop discs and avoid sudden
impact.
b) Do not use dropped or damaged discs.
c) Avoid vibrations or bumps during
work.
d) Avoid damages to the holder hole.
e) Avoid putting loads onto the disc sur-
face.
f) Store grinding discs either flat or
upright, dry, frost-free and at a con-
stant medium temperature.
g) Store grinding discs in the original
packaging or in special containers
and on shelves.
6 – Safety instructions
relating specifically to
the equipment
• For power tools with the X connec-
tion type that require a specially set-
up connection cable to exchange the
connection cable: When the connec-
tion cable of the power tool is dam-
aged it must be replaced by a spe-
cially set-up connection cable that
may be obtained via the customer
service organisation.
• Before changing the tool or carrying
out maintenance work, pull out the
power plug and wait until motor and
spindle have come to rest.
• Do not press the spindle lock until
motor and spindle have come to rest.
• Do not use cutting disks which exceed
the maximum diameter stated.
• When fixing accessory tools to the
machine, note the correct direction of
rotation of machine and accessory.
• The permitted rotation speed of the
accessory tool must not be less than
the idling speed of the machine.
• If necessary, wear hand, eye and ear
protection.
• Switch the machine on immediately
before contact with workpiece.
• Never lay the machine aside when it
is still running.
• Secure workpiece with clamps etc.
• Never use cutting disks for rough
grinding.
57
WU5405070_Bedien-2009.indd 57
WU5405070_Bedien-2009.indd 57
14.09.20 15:07
14.09.20 15:07
