Meilhaus Electronic ME-1400, Electronic Manual

Page: 6 / 29

 Ensure that no static discharge occurs while handling the
board or while connecting/disconnecting the external cable.
Ensure that the connection cable is properly connected. It must be
seated firmly on the D-Sub connector and must be tightened with
both screws, otherwise proper operation of the board cannot be
guaranteed.
1.1.2 Improper Application
PC plug-in boards for the PCI- or CompactPCI-bus may not be taken
into operation outside of the PC. Never connect the devices with
voltage-carrying parts, especially not with mains voltage.
Make sure that no contact with voltage-carrying parts can happen
by the external wiring of the device. As a basic principle, all
connections should only be made or removed in a powered-down
state.
1.1.3 Unforseeable Misapplications
The device is not suitable to be used as a children’s toy, in the
household or under unfavourable environmental conditions (e.g. in
the open). Appropriate precautions to avoid any unforeseeable
misapplication must be taken by the user.
1.1.4 Warning
The device was developed and produced in accordance to the EMC
low-voltage-directive 73/23/EWG. When putting the device into
operation, especially with voltages greater than 42 V, please follow
the appropriate standards, installation instructions and national
safety standards. Meilhaus Electronic GmbH assumes no
responsibility for damage in case of faulty installation, operation or
handling.