Operating instructions for trolley washing machine model WS 125
9648649
Design and construction subject to change without prior notice!
Page
26
of
38
Optional drying
Drying begins after finishing the fresh water rinsing and the dripping phase. In this
process, heated fresh air as well as air drawn from the room is blown directly onto the
trolley. This removes the majority of the water.
Machine design
The machine casing, tanks and cladding are made from 1.4301 grade (type 304)
stainless steel.
Double-wall insulation
The machine’s chambers have double walls with intermediate insulation to reduce the
noise level and the amount of heat which is radiated from the machine. The cavity is 40
mm wide in the region of the chambers.
Voltage data
See electrical wiring diagram
The machine is installed ready. for connection to the power supply and operation The
individual circuits are protected against short-circuits, over-load and single-phase
operation. The operating state is identified by pilot lamps or the touch panel.
The machine control is via a programmable logic controller
(PLC control).
16
Help yourself in case of faults
Malfunction:
Remedy
Machine does not fill!
•
No water present
•
Dirt trap clogged
•
Level electrode / float valve soiled
•
Solenoid valve faulty
•
Suction or pressure pump defective
Malfunction:
Remedy
Final rinse does not spray!
•
No water present
•
Dirt trap clogged
•
Solenoid valve faulty
•
Pump for pumping water from the machine cistern
broken down
•
Final rinse system is scaled
Malfunction:
Remedy
Vapours drain!
•
Suction system has failed
•
Temperatures too high
•
Wash arms, drying nozzles, air guide plates bent or
not correctly inserted
Summary of Contents for WS 125
Page 38: ......