2.3 Microscope Set Up
•
As a first step, remove all components from the shipping container and remove
the packing materials and place the microscope frame on a stable work surface.
•
Loosen the clamp screw on the microscope limb and install the vertical
illuminator (MA806). Once the thumbscrew is tightened, place the binocular or
trinocular head (MA657/05 or MA655/05) onto the top of the illuminator and re-
tighten the clamp screw while the head is in the correct position.
•
Install the two eyepieces (MA406 and MA413CF) by sliding them into the head
and then install the rubber eyeshields on top of each eyepiece.
The MA413CF
focusing eyepiece installs on the right hand side. The shiny pin aligns the
crosshair reticle into the slot on the eyetube.
•
Remove the objectives from their objective cases while being careful not to touch
any part of the optics. Then, screw each objective into a nosepiece opening. Install
them incrementally or in order of power (e.g. 5, 10,
20, and 50).
•
Un-package each digital micrometer and install the
two 164-162’s into the stage. One may need to
loosen the Allen bolts that clamp the micrometers
into place. If a Z-axis micrometer was purchased,
install it onto the focus block as seen at right.
•
Insert the fiber optic light guide into the vertical
illuminator and tighten it in place with the two
Allen screws on the port. Next, plug the power
cordset into the fiber optic light source and the other
end into a grounded outlet.
The mains power cord should only be plugged into a known grounded outlet.
A simple outlet tester can be used to verify correct outlet polarity and the presence of a
grounded circuit. If no other accessories are going to be installed, the instrument is now
ready for use.
