MEI Cashflow SC83 Series, Installation & Operation Manual, Page: 10 / 30

MEI CASHFLOW SC83 Page-10
www.meigroup.com Part # 252055088 G6
INSTALLATION
Mounting Holes
(use M4 screws)
Mounting Holes
(use M4 screws)
Bottom
Back
Side
Note: Always power down machine prior to Installation.
The cashbox does not lock to the chassis. When you remove the unit from the container or when the unit is not installed
in the machine, you must never carry the bill acceptor by the handle of the cashbox. The cashbox may release causing
the rest of the unit to fall and damage the chassis.
Note: Not suitable for use in areas where there could be direct contact with water jets.
Installing The Chassis
• Most models have a configuration-specific cable installed
on the back of the chassis (see Interface Manual 002850103
for more details). Connect the cable from the chassis to the
machine. Always dress all wires to avoid interference with
any equipment operation.
Note: If you have a custom configuration, you may need to contact our technical support group for assistance.
• Once the connections are made, you will need to line up the locating holes on the bottom of
the chassis with the machine’s locating pins. Line up the mounting screw holes and insert M4
screws through several of the 10 mounting holes. There are three on each side of the chassis and
four located on the back. Leave screws slightly loose until the bezel is mounted and aligned with
the machine door closed. Screws must not exceed a 6mm depth through the mounting plate,
otherwise they may interfere with the removable cashbox.
Earth Grounding Considerations:
Use star washers when mounting the chassis via the rear mounting holes to ensure the chassis has a
good electrical connection to the machine’s mounting plate. When using the side mounting holes
ensure the lower (upper if Up Stacker) mounting hole is used.
Locating Holes