www.megger.com
30
Setup options
GFCI:
Not relevant
Ground testing:
Ground measurements are saved under a job number only
Storing Test Results in the internal memory
In order to store test data, the Store Mode needs to be set to internal or internal and Bluetooth
®
. Refer to
“Bluetooth® Pairing” on page 32 for further details.
1. Perform the desired test as described previously.
2. Press and release the Bluetooth
®
(Lock)
button to display the first option. This will be the connection
for some tests (Insulation, Continuity, Loop L-L/L-N) or Job number for other tests.
3. Use the Right Lock
/ Right Test
buttons to scroll through the values until the one you need is
reached.
4. Press and release the Bluetooth
®
(Lock)
button again to display each of the remaining options (Job,
Distribution Board, Circuit, Phase) and use the Right Lock
/ Right Test
buttons to change these
values as required.
5. To complete the store, press and hold the Bluetooth
®
(Lock)
button until ‘Str Ok’ is displayed.
Note
:
If a particular option does not need to be changed from the value set during the previous stored result, it
does not need to be displayed prior to storage.
Note:
The only available option for stored ground test results is the Job number.
Deleting Test Results from the internal memory
1. Turn the RIGHT rotary range knob to the DEL
DEL
range.
2. Use the Bluetooth
®
(Lock)
button to select either LSt (last stored result) or ALL (all stored results).
3. Press and hold the Bluetooth
®
(Lock)
button until ‘NO’ is displayed.
4. Use the Right Lock
/ Right Test
buttons to display ‘YES’.
5. Press and hold the Bluetooth
®
(Lock)
button until ‘dEL Ok’ is displayed.
