8
Attaching the Main W
ing
The Air Strike Radio System
B.
Attach 4 wing bands. Install one on each side in a II
pattern. Then Install two bands in a X pattern (Crossed
over each other). See
Figure 6.
C.
After the wing bands are installed, check the wing once
again to make certain that it is still perfectly centered.
When perfectly centered, make an alignment mark (use a
pencil or felt-tip marker) at the front and rear of the wing
where it meets the fuselage. The marks will make it easier
to align the main wing next time you install it.
Alignment Marks
Figure 6 - Attaching the Main Wing
Important Note!
Disassemble your Air Strike
®
when not fl ying.
This will help reduce the chance of accidental damage.
This aircraft uses a 3-channel R/C (radio control) system. See
Figure 7.
The stick on the left side of the transmitter operates the motor. When this
stick is all the way in the “down” position, the motor is off. Power
increases as the stick is moved up. Full power is reached when the left
stick is positioned fully “up”. The right stick controls the elevator (up and
down) function and the rudder (right and left) function.
