Megasat HSC 7800, Quick Start Manual

Page: 11 / 19

Content 1. Safety instructions
2. Delivery
ENGLISH ENGLISH
02
• Make sure that the device is installed in a well-ventilated and dust-free environment.
• The device is intended for indoor use only.
• Keep all liquids away from the device.
• Make sure the environmental conditions are in accordance with the factory specifications.
• Heavy impact or impact on the unit due to falling may damage the sensitive electronics inside the unit.
• Turn off the device before connecting and disconnecting accessories and peripherals.
• A factory recommended hard disk should be used for this unit.
DVR main unit
• HSC 7800
• 48 V DC power supply
• BNC cable (18 m)
• User manual
Kamera
• HSC 20
• Screw set
• User manual
• The correct configuration of all passwords and other security settings is the responsibility of the installer and
/ or end user.
• When using the product, you must strictly adhere to the electrical safety regulations of your area. Detailed
information can be found in the technical data.
• The input voltage should meet both SELV (Safety Extra Low Voltage) and Limited Current 100 ~ 240V AC, 48V
DC IEC60950-1. Detailed information can be found in the technical data.
• Do not connect multiple devices to a power supply as overloading the adapter may cause overheating or a
fire hazard.
• Make sure the plug is firmly connected to the power outlet.
• If smoke or odor comes from the unit, immediately turn off the unit and disconnect the power cord from the
wall outlet. Then contact your dealer.
Warnings
Precautions
03
1. Sicherheitshinweise
........................................................................................ 03
2. Lieferumfang
........................................................................................................ 03
3. Bezeichnungen und Anschlüsse
3.1 Vorderseite ......................................................................................................... 04
3.2 Rückseite ............................................................................................................. 04
4. Einbau einer Festplatte
................................................................................ 05
5. Erste Schritte zur Inbetriebnahme
5.1 Inbetriebnahme des Geräts .................................................................... 06
5.2 Gerät aktivieren ............................................................................................... 06
5.3 Assistent bei Systemstart .......................................................................... 07
6. Kamera anschließen und in Betrieb nehmen
........................... 10
7. Das Schnellstartmenü
................................................................................... 11
8. Aufnahmeplan einstellen
.......................................................................... 12
9. Einstellungen der Festplatte
................................................................... 14
10. Wiedergabe von Aufnahmen
............................................................... 15
11. Technische Daten
........................................................................................... 16