System Components
Antenna unit
The elegant plastic housing will protecting the antenna
against outside weather conditions. Under the housing the-
re is a high-performance antenna. The new technology of
15-55° elevation enables optimal reception across Europe.
Control unit (IDU)
The control unit is used for satellite selection and control. It
is connected between the antenna and the set-top box and
supplied the antenna with electricity. After successful align-
ment, the device automatically switches to standby. For a
complete shutdown, press the power button.
Open box and remove the control unit, cables and packing material. Lift the antenna
straight up out of the box. Never place the system upside down!
ENGLISH
ENGLISH
04
05
Warning:
The Campingman GPS/Twin has an additional connection for a second set-
top box. The control unit must be operated only on the selected „POWER
LNB1“ port. Only this is provided for controlling.
Installation
Warning:
Please also note that the antenna height of the vehicle will change accordin-
gly! Please strictly adhere to the various points in the installation instructions!
Basically, we recommend that you leave the installation to make by your dealer or work-
shop!
General information:
Provide a suitable working environment, a garage/warehouse is better than open air. The
ambient temperature for installation is b5° C and max. +25° C. Work not directly
in the sun. Comply with the safety regulations when handling with chemical products.
Provide the necessary hygiene.
Preparation:
1. Make sure that the roof of your vehicle is sufficiently stable. In case of insufficient or
doubtful roof stability is an approximately 2 mm thick plate with 100 x 100 cm is to be
attached to the outer roof skin. Ask to your vehicle manufacturer.
2. Make sure that all parts are present. You may also need a roof penetration for the con-
necting cable of the antenna. This you get in specialist shops.
3. Place the antenna on the installation area and align it so that the antenna connection
is not facing forward. Make sure that the mounting location is flat and do not interfere
with roof constructions that can interfere with satellite reception. Constructions up to
8 cm in height do not matter, higher constructions should have a respective distance
from the antenna, so that no barrier exists between the antenna and the satellite. The
least distance to an air conditioner should be 30 cm.
4. Clean the mounting surface with a suitable cleaner and a fleece cloth to remove dirt
and impurities. Then draw the antenna feet with a pen.
Warning transport safety:
Open the antenna and
remove both thumbscrews.