![background image](http://html.mh-extra.com/html/megasat/1500181/1500181_user-manual_1765069014.webp)
08
09
ENGLISH
ENGLISH
2. Installation
2. Installation
2.5 Connecting the components
Plus ignition
Power supply:
The Traveller-Man automatically moves to the retracted position when the ignition key is
turned. This function is only available when the cable
4
and
5
are connected. Once the
antenna is retracted, the LEDs light up on the control unit of the satellites in succession.
12-24 V DC via battery (positive-per-
manent systems) or optional DC po-
wer supply 230V/12V (no charger).
Ensure that a current is assured of at
least 5 amps.
Note:
During the registration process no
charger should be connected to the
car battery!
Coax cable 10 m
Positive pole
Coax cable 1 m
Negative pole
Plus ignition
1
2
3
4
5
Warning:
Connect the device only at a 7 amp
protected line. The line must be at least
2.5 mm² strong. (never directly to the car
battery).
Control unit
(+)
(-)
TV
(+) (-)
1
2
3
4
4
5
TV
not in
Included!
F-connector
WITHOUT
marking
F-connector
WITH
marking
Second connection
(optional)
1. The coaxial cable is routed inside the vehicle.
2. When choosing the location for the controller and the satellite receiver, make sure
that both units are in a dry and sheltered place.
3. Keep the controller and the satellite receiver away from heat sources and provide
adequate ventilation.
4. The basic connection options for the antenna system are shown below:
• Connect the power supply (red-black wire) for the controller to your vehicle‘s
battery via a fuse (7 amps) to prevent cable burn in the event of a short circuit. The
yellow cable is connected to the ignition plus of the vehicle and also secured with
a fuse of 7 amps (this cable only needs to be connected if the antenna is to start
automatically when the engine is started.). The remaining black cable is connected
to the corresponding negative pole of the ignition system (ground).
• Connect the cable coming from the antenna to the controller:
- 10 m coaxial cable with F-connector in „ANTENNA“
• Connect the controller to the satellite receiver:
- 1 m coaxial cable with F connector from „RECEIVER“ to the satellite receiver
2.4 Indoor installation
Note:
If you want to operate two televisions, connect a second coaxial cable from the
antenna directly to the second satellite receiver.
Summary of Contents for 1500181
Page 1: ...Bedienungsanleitung Traveller Man ...
Page 28: ......