5
Instillation
Caution!
1. The installation must be carried out by an authorized dealer or trained professional.
2. Unit may cause severe injures if you have doubts concerning the safety do not install.
3. Unit is to be 24inches away from flammable materials (decoration material)
When installing the fixture it is very important that you follow common safety procedures. Instillation requires extensive
experience including but not limited to calculating working loads, material being used and periodic safety inspections. If
you lack these qualifications, do not attempt the installation yourself, instead use a professional structural rigger.
The installation location of the Fixture has got to be built in the way that it can hold 10 times the weight for 1 hour. Instal-
lation should be checked at least one time every 2 years by a skilled person.
Installation
Step 1: Remove the suspension brace
(Fig1)
by
removing the side screws
(Fig3)
on the canopy.
Step 2: Secure the suspension brace to the electri-
cal box with screw
(Fig2)
Step 3: Make necessary power connections using
the RJ45 in and out connections
Step 4: Secure the canopy to the suspension brace
using
(Fig3)
screws
Height Adjustment
Step 5: To adjust the height of the pendent press
on the center part of the steel cable holder and
push the cable inwards. This will release the steel
support cable allowing you to adjust the desired
height there is a maximum of 8 feet cable length to
be adjusted.
Step 6: Deco PQ20 uses a 2 part cable strain re-
lief. Too loosen start by holding bottom part of the
strain relief and unscrewing the top part this will
allow the excess power cable to be stored inside
the fixture.
Fig1
Fig2
Fig3
