stage three,
activating the batteries
Caution:
Please ensure the batteries are correctly installed, observe the correct polarity as the PCB may be
damaged if this is not carried out.
Remove the paper insulator from the lithium 3Vcc battery.
Confi guring your Megalarm wireless system
First mark one of your P300W units as your master unit (label or write ‘Master’ on the back)
To Cancel the connection with a smoke detector or a stand alone alarm during the set up process
While in step 2 anywhere between points 3 and 8 and you encounter a problem or are not sure that you pressed
the right button, press the confi guration button for 10 seconds until you hear 4 long beeps which confi rms that any
connections have been cancelled.
1. Open the master unit and the fi rst slave unit.
(Slave unit is either another P300W, C300W or D300W)
2. Place the slave next to the master unit.
3. Press the CONFIG button in the slave unit for 5 seconds,
the unit will beep to indicate each second, and then release.
This does not apply to the D300W - see Step 3.
4. Once the unit has sent the confi guration signal the buzzer will pulse
and the amber LED will illuminate.
The slave now sends a request to be combined with the master.
This is indicated by 1 beep every 3 seconds
5. Press the VALID button in the master until you hear a long beep and
then release.
6.
The slave is now linked to the master unit and will now enter the ‘signal
strength’ mode.
7. Take the slave to the preferred location and ensure the signal strength is
adequate, the unit will beep indicating the signal strength. You should try to
achieve at least a signal strength of 3
Number of Beeps
1
2
3
4 5
Signal Strength
Very weak
Weak
Medium Good Very good
0330 999 2233
www.fi redepot.co.uk
sales@fi redepot.co.uk
4
