03282008
2. Within 5 seconds, enter your chosen 10ths digit by press and release the Valet Switch.
(When finished above procedures, system's siren stop alarming, parking light stop flashing, but the
vehicle cannot be start and drive away.)
3. Turn the ignition switch “OFF” position.
[4] Chirps form siren/horn, [3] flash from parking light and LED will turn off to indicate the system was
disarmed.
Note 1: You must override the alarm within 60 seconds. If not, the system will automatically re-arm.
J. VALET MODE:
The valet switch allows you to temporarily bypass all alarm functions, eliminating the need to hand your
transmitter to parking attendants or garage mechanics. When the system is in valet mode, all alarm function
are bypassed, however the remote panic feature and remote door locks will remain operational.
Enter Valet Mode:
1. Turn the ignition to “ON” position.
2. Push and hold valet switch for 2 seconds until the LED turns on. The LED wills
remain on as long as the system is in 'valet mode'.
Exit Valet Mode:
1. Return to normal operation, turn ignition 'ON'.
2. Push and hold valet switch for 2 seconds, The LED will turn off indicating the
system has exited the valet mode.
K. PANIC FUNCTION:
The transmitter can be used as a remote panic switch to manually trigger the alarm in case of emergency.
1. Press and hold the
button on the transmitter for 3 seconds. The alarm will immediately sound.
2. To stop alarm, press and hold
or
button on transmitter, panic mode will be turned off immediately.
3. If the button is not pressed, the alarm will automatically stop after 30 seconds.
Note: If the H3/6 Gray Wire is not Trunk release Output, (See Alarm Feature
III-2
Programming), Press and
hold the
/ AUX
button on the transmitter for 3 seconds. The alarm will immediately sound.
L. TRIGGER THE SYSTEM
When armed, your vehicle is protected as follows:
1. Light impacts will trigger the warn-away signal. A long chirp from siren/horn.
2. Heavy impacts / Doors open / Hood open / Trunk open / Turns on the ignition switch will trigger the
programmed sequence.
The starter disable relay (if installed) prevents the vehicle’s starter from cranking. The siren and parking lights
will turn on to alerting of an intrusion for 30 seconds. Then it will stop and automatic reset and re-arm. If the
one of sensors or detectors is still active, alarm system will sound a maximum of 6 times.
M. ANTI CAR-JACKING
Warning:
If you do not need the car jacking function in this alarm system, be sure to set car jacking feature
“OFF”. This systems default setting is car-jacking “OFF”. (See Alarm Feature
III - 3
Programming.)
ACTIVE ANTI CAR JACKING:
1. Upon ignition is “On”, press and hold the transmitter
and
buttons at the same time for 2 seconds.
The parking lights will turn on for 1.5 seconds to indicate the system enters the car-jacking mode.
2. Once the system is in car-jacking mode, if you are forced from the vehicle, the system will be triggered
when the door is opened and closed while the ignition is “ON”.
TRIGGER THE CAR JACK MODE:
a). 50 seconds after the system has been triggered, the siren will start chirping for 15 seconds.
b). During this 15 second period of chirping, you will be alerted to push the valet switch once to turn off the
car-jacking feature. If not, it will enter second timer car jacking.
c). 65 seconds after the system has been triggered, the siren starts alarming and the parking light starts
flashing.
d). 90 seconds after the system has been triggered
1. The siren still alarming and the parking light flashing, and
2. The starter disable will activate to prevent the vehicle from starting.
3. It will remain active until the vehicle's battery power is exhausted.
OVERRIDE THE SYSTEM TO TURN OFF CAR JACKING:
Turn the ignition switch from OFF to ON, and within 10 seconds push valet switch, the siren will stop and
the system disarmed
Note:
If password pin code is used to protect vehicle security, you will need to use it to disarm the system.
O. IGNITION CONTROL DOOR LOCKS.
(See Feature
II – 3
Programming.).
If the vehicles door locks have been interfaced to the security system, system will automatically lock vehicle
doors when the ignition is turned “ON” and /or unlock vehicle doors when the ignition is turned “OFF”.
P. TRUNK RELEASE.
(See Feature
III – 2
Programming.)
Press and hold
/ AUX
button for 2 seconds to remotely control trunk release or other electronic device.
Q. CAR LOCATOR
Press
button
on transmitter to active car locator. Siren will chirp 6 times. Parking light will flash 12 times.
MEGA 470/474; VS 465/474L
10
