Laminate Your Value
Installation, assembly and dismantling
The MEFU Laminator should be assembled and used in a clean room with a
normal room temperature and normal humidity levels. The work place should
be dry and ventilated. Do not use this machine near water source or wet
ground. This minimizes the occurrence of static electricity. In the meanwhile,
do not close to combustible and explosive goods.
Delivery inspection
When the machine is delivered, the following units are included:
·
MEFU laminator
·
Manual
·
Accessories
Connections
Voltage:
AC220/240V 50-60HZ
Positioning
The MEFU Laminator should be placed in a dry and ventilated situation.
Electrical connectors may only be connected to
socked to sockets with the correct voltage. All
other operations may only be performed by
authorized staff.
Before use
Check the wheelwork (at a regular time), clean and lubricate.
Using
The roller is hot during working, please do not touch it,in case of scalded or bruised.
After use
Place the roller in the idle position, raised 5 mm above the working table.
Clean the roller at a regular time, do not use water to clean the machine in case of short
circuit, electric shock or rust.
Use 80% alcohol, detergent or eraser to clean the rollers after lamination, which can
lengthen the rollers' life.
1.The temperature of the roller should under 40
℃
and stop heating.
2.
Do not focus on one point.
3.
Clean the residuum in time, otherwise it will affect the yields.
Assembly with the steps performed by technician
authorized.
7
