Laminate Your Value
Repairs
Contact a technician
You should first try contacting a technician through the dealer where you bought your Laminator.
If this is not possible, contact MEFU Technical Service
Phone: +00 86 15890020566
Accessories
For any necessary accessories you need, you can try to contact the dealer where you bought your
MFEU Laminator.
The equipment may only be used for its intended
purposed as specified in this manual. For any
other use may result in damage or injury, and is at
the user’s own risk.
11
Troubleshooting
The roller won’t move up and down
1.Reset the emergency stop button.
2.Reset the controls
(If none of this helps, please contact a technician)
Control panel dead fault
1. Check power supply or emergency button.
2. If the fuse is burn down, just replace.
The roller can not run
1. Regulate the fraction of the rollers
2. Fix or regulate the chain wheel key on the
motor shaft
3. If Motor or speed controller breakdown, Just
replace the motor or the speed controller.
Snow points
1. Rises up the temperature
2. Clean the surface of graphic
3. If there is some problems with the film,
change the film.
Air bubbles or folds
1. Adjust the pressure of the rollers.
2. Make the printings flat
3. Improve speed or lower temperature.
4.
Put the beam weight on printings
Printings go tilt
Regulate the pressure of the rollers.
Folds of films
1. Regulate the film roll's fraction
2.
Lower the temperature
Finished products are too curled
Regulate the tension of the film or the reception
roll
