21
Large workpieces
If cutting large workpieces, ask someone else to help you hold them.
Angled cutting
The table must be set at an angle to perform angled cuts. Set the table at an angle as shown below.
1.
Loosen the knobs in the figures below.
2.
Set the table at the required angle according to the scale by the front knob
3.
Lock the knobs in the figures below.
Before cutting, check that:
•
the knobs are tightened.
•
the fence is secured firmly.
•
the fence is straight and parallel to the blade.
MAINTENANCE
Changing the blade
Change the saw blade as follows:
1.
Remove the saw blade guard by unscrewing
its screw in the splitting knife
2.
Loosen the screws A and remove the guard B.
3.
Use a 19 mm spanner D and loosen the axle
nut C. Hold the shaft with an 8 mm spanner F.
4.
Remove the saw blade E.
5.
Clean the saw flange.
6.
Fit the new saw blade and ensure that the
arrow faces in the direction of rotation.
7.
Assemble the parts in reverse order.
Changing the table insert
1.
Remove the blade guard A by unscrewing the screw B.
2.
Remove the six screws C and remove the table insert E.
3.
Install the new table insert in the reverse order