EN
14
particle size must be checked to prevent
fish being sucked into the pump.
Symbols
Max submersion depth.
Approved as per applicable
directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Rated voltage
230 V ~ 50 Hz
Output
300 W
Protection rating
IPX8
Coupling 1/2"
Max flow
36 l/min
Max delivery height
11 m
Max submersion depth
7 m
Max water temperature
35°C
Max particle size
19 mm
OPERATION
Range of applications
• The pump may be submerged wholly or
partially under the surface of the liquid,
and can be used for pumping clean or
slightly contaminated liquids.
• Ensure that the pump is never operated
when dry.
NOTE:
The pump must not be used for pumping salt
water or flammable, corrosive, explosive
or dangerous liquids.
SAFETY INSTRUCTIONS
• Follow the safety instructions to avoid
personal injury or material damage.
• The pump must not be used to pump
saltwater or flammable, corrosive,
explosive or dangerous liquids.
• Make sure the pump is never run dry.
• Keep your hands away from the pump
inlet when it is plugged into the mains.
Risk of personal injury.
• Check that the power supply to the pump
is disconnected before it is installed.
• Use the handle to move or lift the pump.
• If the pump is to be used in a permanent
installation with rigid piping it is necessary
to install a check valve to avoid the
recirculation of water when the pump
stops. An easily accessible ball coupling
should be installed to simplify cleaning
and maintenance.
• If the pump is to be used in temporary
installations a flexible tube should be
installed and connected to the pump.
• Use a rope and fasten it to the handle
when lowering down the pump.
• Minimise the number of starts per hour.
• Pumps used near pools, ponds, small
lakes etc. should be fitted with a switch.
Consult an authorised electrician.
• The power cord on the pump must only be
replaced by an authorised service centre.
• The pump must not be used in pools or
other places where people come in
contact with the water.
• Check that the pump has been
disconnected from the power supply
before any maintenance.
• The pump is not intended to be used for
table fountains and aquariums.
• If the pump is used in continuous mode
in fish ponds it must be checked every
6 months (if the water contains
aggressive substances).
• The pump’s recommended maximum
