ENGLISH
32
Table extensions (J)
1.
Mount the blade holder so that it is easily accessible.
2.
Place a ruler on the worktable so that it rests against the front and rear table extensions (J).
3.
If the table extensions (J) are not flush with the work table, loosen the nut (P) and turn the screw (Q)
until table extension’s rollers and the work table touch the ruler. Adjust both the left and right-hand
table extensions (J).
Parallelism setting
This setting is made at the factory.
Poor parallelism is usually caused by misaligned blades. Always check that the blade holder and the work
table are parallel before attempting to adjust the parallelism setting.
Procedure
1.
Place the machine on its side
and loosen the clamp (S) (fig.
1).
2.
Move the conical gear wheel
(T) towards the clamp until it
runs freely from the second
gear wheel (fig. 2).
3.
Turn the second gear wheel to
adjust the height of the blade
holder on the side where the
gear wheels are located. One
tooth shifting anti-clockwise
raises the blade holder 0.1 mm.
