ENGLISH
43
Pressure bearing adjustment
1.
Loosen the 2 screws and remove the U
bracing.
2.
Loosen the 3 screws and remove the table.
3.
Move the upper saw blade guide upward as
far as it will go.
4.
Adjust and tighten the saw blade, if
necessary.
5.
Loosen the pressure bearing's clamping
screw (51). Adjust the pressure bearing. The
distance between the bearing and blade
must be 0.5 mm. Turn the saw blade by
hand to check that it is not touching the
bearing.
6.
Tighten the pressure bearing's set screw
(50).
Guide pin adjustment
1.
Loosen the screws (56) using a hex key.
2.
Press the guide pins (54) together and against the saw blade.
3.
Turn the saw blade by hand several times and adjust the guide pins so that both pins are slightly
touching the blade.
4.
Secure the table.
5.
Mount the U bracing under the table.
Changing the table insert
Replace the saw table insert if it is damaged or worn.
1.
Press down on the insert to remove it from the table.
2.
Fit a new insert.
MAINTENANCE
Turn off the tool, unplug the power cord and wait until all moving parts have stopped completely
before cleaning, measuring, changing accessories or other interventions.
Refit all safety devices and guards following repairs and maintenance.
The sealed bearings are maintenance free.
Cleaning the saw
1.
Open the door.
2.
Remove dust and wood chips with a brush or vacuum cleaner.
3.
Close both the doors.
Recommendations
Apply a light lubrication to the table's swivel device and the blade tensioning device.
Regularly clean resin and other substances off the saw blade using a suitable cleaner.
Regularly inspect the guide rollers and pressure bearings. Adjust and lubricate the parts or replace
them as required.
Replace the saw table insert if it is damaged or worn.
Clean resin and other particles off the table.
