Meec tools 082-210, Operating Instructions Manual, Page: 16 / 18

ENGLISH
16
OPERATION
Appropriate air pressure is 2.0
–2.5 bar.

The recommended paint viscosity varies depending on the
paint’s characteristics and surrounding conditions when
spraying (18 ± 2 s recommended).

Use the lowest possible outgoing flow. It gives better surface
results with atomisation.

The distance between the spray gun and the workpiece should
be as small as possible (150
–200 mm).

Always hold the spray gun perpendicular to the workpiece
surface.

Move the spray gun in straight lines horizontally.

If you move the spray gun in turns, the paint coat will be uneven.
MAINTENANCE
WARNING:

Turn off the air and fluid flow to the spray gun and relieve the pressure by pressing the trigger before
disassembly, cleaning and/or service.

The spray gun contains sharp parts
– risk of cut injuries.

The product must only be dismantled by persons who have had proper training.
1. Pour remaining paint into another container and clean the paint ducts and air cap. Spray a small
amount of solvent to clean the paint ducts. Inadequate cleaning can cause incorrect patterns and/or
particles in the paint. Thoroughly clean the spray gun immediately after using two-component paint.
2. Clean the other parts with solvent and the included brush and a cloth.
3. Clean the paint ducts fully before dismantling the spray gun.
4. Remove the paint needle before removing the paint nozzle, or hold the needle retracted, otherwise
the seat may be damaged.
5. Insert the paint needle and screw on the paint needle seal by hand. Tighten carefully with a spanner.
Adjust the seal while you press in the trigger and check how the paint needle moves. Do not over-
tighten, as the paint needle moves slower, which will result in leakage from the nozzle tip.
6. If this is the case, loosen anti-clockwise until the needle moves freely without paint leakage.
7. Turn the pattern knob anti-clockwise to the fully open position and screw in the pattern guide in the
body.
IMPORTANT: Only use spare parts and accessories recommended by the manufacturer.

Never immerse the spray gun in solvent or other fluid.

Be careful never to damage the holes in air cap, paint nozzle or paint nozzle