28
INSTALLATION
Dismantling
To remove accessories, turn the lock ring in the direction of the arrow and pull the accessory out from the
tool. Carefully press the rubber cap on the tool.
OPERATION
Charging the battery
The battery for this power tool only has a low charge on delivery. Charge the battery before using it for
the first time.
Plug the mains adapter into a power outlet and connect the other end to the DC connector on the tool.
It normally takes 3-5 hours to fully charge the battery. It can take up to 7 seven hours the first time it is
charged, depending on the ambient temperature and battery charging status.
Before using for the first time
Fully charge the battery (5
–7 hours) and use the tool until the battery is discharged and the tool starts
moving more slowly. Charge the battery for 5-7 hours and use the tool until the battery is discharged
again. Repeat this charging cycle 4 or 5 times to prevent memory effect. The battery can then be charged
normally.
IMPORTANT:
The charger does not have overcharge protection. Do not charge the appliance for too
long. There is a risk of the damaging batteries if they are overcharged. Unplug the charger power cord
after charging.
PREPARATIONS
Starting/stopping
Start the tool by pressing the power switch.
Switch off the tool by releasing the power switch.
Fitting bits
IMPORTANT:
Unplug the charger and check that the direction selector is in locked position.
Bits
Only use single bits with a minimum length of 25 mm. Shorter bits can get stuck and be more difficult to
remove.
Power switch
Start the tool by pressing the power switch. Keep the power switch pressed for continuous use.
NOTE:
The tool does not have variable speed.
Direction selector
Move the rotation selector to the right for left drive. Move the rotation selector to the left for right drive.
The middle position locks the tool in the Off position.
Predrilling
You can predrill screw holes to simplify screwdriving.
Use
Only use bits that fit in the magnetic 1/4” bit holder. Always check before use that the bit is correctly fitted.
Do not tighten screws too hard, this can damage the screw heads and/or threads.
Screwing/undoing
Select a bit that fits the screw head.
Insert the bit in the magnetic 1/4” bit holder. Hold the tool with the bit in line with the screw, otherwise the
screw can be damaged. Press the tool firmly against the screw, otherwise the bit or screw head can be
damaged.
Press the power switch to start the tool. Release the power switch immediately when the screw is
screwed in, otherwise the bit or screw head can be damaged.
Summary of Contents for 060-112
Page 30: ......
