ENGLISH
33
1.
Template guide bush
2. Template
guide
3. Workpiece
NOTE
The template guide is only intended to be used together with templates. It must be removed before
normal machining. If the dust extraction mechanism is in the way of the template guide, you can fit the
template guide without the dust extraction mechanism by using the supplied M5 nuts.
Parallel fence
The parallel fence is used when milling grooves parallel to the edge of the workpiece. Fit the parallel
fence on the guides. Insert the guides in the openings on the side of the baseplate and adjust the
required gap between the parallel fence and the bit. Lock the guides in the baseplate with the screws.
1. Locking
screw
2. Baseplate
3. Guide
4. Parallel
fence
Centring pin
The centring pin is used for milling circular contours. Remove the parallel fence. Clamp the centring pin
on one of the guides by tightening the wing nut. Insert the guide in one of the openings on the side of the
baseplate and adjust the required gap between the centring pin and the bit. Lock the guide in the
baseplate with the retaining screws.
Depth stop
Adjust the depth stop by releasing the locking lever and pressing the tool handle until the required depth
setting is reached. Lock the locking lever again.
