ENGLISH
30
Switch off the tool, unplug the power cord and wait until all moving parts have stopped completely
before carrying out any cleaning and/or maintenance. Unplug the power cord when the tool is not in
use.
Switch off the tool, unplug the power cord and wait until all moving parts have stopped completely
before attempting to remove cuttings or bits etc.
The tool is only intended for machining wood and other similar materials.
Before use
Always check before use that the tool, power cord and plug, including any accessories, are
undamaged.
Do not use the tool if it is damaged.
Always check that all the parts are correctly fitted before use.
Make sure the power switch is in the OFF position before plugging the plug into the mains supply.
Check that the mains voltage corresponds to the rated voltage on the type plate. The mains plug
on the power tool must match the mains outlet.
The tool must only be connected to an earthed mains socket.
WARNING
If the power cord or plug are damaged, they must be replaced by authorised service
personnel to ensure safe use.
Maintenance
The power tool must only be serviced by qualified service personnel using identical spare parts. This will
ensure that the power tool remains safe to use.
TECHNICAL DATA
Rated voltage
230 V ~ 50 Hz
Output 1020
W
Speed (no load)
16,000 – 30,000 rpm
Collet 8
mm
Sound pressure level, LpA
91 dB(A), K=3 dB
Sound power level, LwA
102 dB(A), K=3 dB
Vibration level
4.1 m/s², K=1.5 m/s²
Always wear ear protection!
The declared vibration value, which has been measured by a standardised test method, can be used to
compare different tools with each other and for a preliminary assessment of exposure.
WARNING:
The actual vibration level when using power tools may differ from the specified maximum
value, depending on how the tool is used. It is therefore necessary to determine which safety precautions
are required to protect the user, based on an estimate of exposure in actual operating conditions (taking
into account all stages of the work cycle, e.g. the time when the tool is switched off and when it is idling,
in addition to the start-up time).
