Meec tools 016876, Operating Instructions Manual

Page: 26 / 52

EN
26
3. Fit the bit in the screw head.
4. Start the product by pressing the power
switch and holding it in.
5. Release the power switch to switch off the
product.
Screw driving
1. Fit the bit in the screw head while the
product is switched off.
2. Set a suitable torque for the size of screw
according to these instructions.
3. Press the bit against the screw head. Start
the product at low speed and gradually
increase the speed. Release the power
switch immediately if the clutch trips.
4. Hold the product with the bit in line with
the screw, otherwise the screw and/or bit
can be damaged.
Screwing in wood
• When screwing in wood, predrill the hole
to make screwdriving easier and to
prevent the workpiece splintering or
cracking. Use a drill with a diameter of
about 70% of the screw diameter.
• Always predrill when screwing near the
edge of the workpiece.
• It is recommended to use Torx screws or
cross-head screws to work more safely.
• Use bits with a suitable shape and size for
the actual screws.
• If it is difficult to tighten the screws, use a
small amount of detergent or soap as a
lubricant.
LED lightning
The LED light goes on automatically when the
power switch is pressed and illuminates the
area in front of the bit.
IMPORTANT:
• Risk of burn injury. The chuck and bit can
get very hot.
• During prolonged use the chuck and bit
can get very hot. Wear safety gloves
when changing bits.
HOW TO USE
Adjusting the handle
Move the handle by pressing the lock button
(4) and moving the handle to the required
position.
FIG. 4
Selecting the direction of rotation
Press the rotation selector to switch (7) the
direction of rotation.
FIG. 5
Direction of rotation
Position of rotation
selector seen from
above
Right drive/clockwise
rotation/tightening
of screw.
Left drive/
anticlockwise rotation/
unscrewing of screw.
Power switch lock
The power switch can be locked in the off
position. This reduces the risk of accidental
starting. Lock the power switch by setting the
rotation selector in the middle position.
NOTE:
The power switch is locked when the
direction selector is in the middle position.
Starting/stopping
1. Fit the required bit.
2. Set the torque, speed and direction of
rotation.