EN
46
IMPORTANT:
• Never use the shoulder strap diagonally
over your chest, only on the right
shoulder. This makes it easier to move the
pruning saw away from your body in a
dangerous situation.
• Switch off the pruning saw, pull out the
plug and wait until all moving parts have
completely stopped before cleaning and/
or maintenance.
• Check that the catches have returned to
their original positions after adjusting,
otherwise the pruning saw will not start.
• Do not plug in the plug until the pruning
saw is fully assembled. Failure to follow
these instructions can result in the risk of
fatal or serious personal injury and/or
material damage.
Fitting the bar and chain
WARNING!
Always wear safety gloves when handling
the chain.
1. Undo the nuts that hold the guard and bar
in place.
2. Remove the guard by pulling it straight out.
This can require a certain amount of effort.
FIG. 4
3. Put the chain round the bar. Make sure that
the chain is put in the correct direction of
rotation.
FIG. 5
4. Put the bar on the bolts and put the chain
round the sprocket behind the coupling.
Make sure to align the links between the
teeth on the sprocket.
FIG. 6
5. Replace the guard and tighten the nuts by
hand.
FIG. 7
6. Tension the chain by turning the adjuster
screw for the chain tensioning. Tension the
chain according to the instructions in the
section
Checking and adjusting the chain
tension.
7. Use a combination spanner and tighten the
nuts holding the guard.
IMPORTANT:
A new chain must be tensioned after no more
than five cuts. Check the chain tension at
regular intervals.
USE
Before starting
• Check the oil level. Fill the reservoir for the
chain oil to about half of the level glass.
Use chain oil of good quality.
• Check the chain tension and tighten the
chain, if necessary, as described in the
instructions for tensioning the chain.
Connection to mains
1. Put the power cord for the pruning saw in
the de-tensioner before connecting to the
mains.
FIG. 8
2. Use an extension cord for outdoor use.
Starting
1. Start the pruning saw by first pressing
forward the start inhibitor and then
pressing the power switch.
2. Release the start inhibitor when the motor
starts.
FIG. 9
WARNING!
• Never starting the pruning saw if the bar
and chain are not correctly fitted.
Summary of Contents for 004841
