EN
55
USE
Depth stop
Limit the drilling depth with the depth stop (6).
1.
Insert the depth stop in the hole as
shown in the diagram. Make sure the
ruler marking can be seen.
2.
Make sure the end of the depth stop is
level with the tip of the drill. Pull back the
depth stop the required drilling depth.
Inserting and changing drills
Different drills can be used with this product, depending on which material you are working with.
WARNING:
• Always use the right drills for the intended purpose. Never use drills intended for wood to drill in
metal, for example, and vice versa. Take the technical requirements for this product into
consideration (see section on Technical data) when buying and using drills.
• Some drills are very sharp and get hot when in use. Handle them with care. Wear safety gloves
when handling drills to avoid burning or cutting yourself.
1.
Hold the keyless chuck (3) firmly and turn the chuck sleeve (2) anticlockwise until the tool
holder (1) opens enough to insert the drill.
2.
Take out the drill (if there is already one in) from the tool holder and insert the new drill all
the way into the tool holder.
3.
Hold the keyless chuck firmly and turn the chuck sleeve clockwise until the drill sits firmly in
the tool holder.
Connecting to power source
1.
Make sure the power switch is in the OFF position.
2.
Plug the plug into a suitable power point.
WARNING:
Check the voltage. The voltage must
correspond with the information on the label.
3.
The product is now ready to use.
Summary of Contents for 000-138
Page 61: ......
