8
SETUP:
PAIRING WITH BLUETOOTH HEADPHONES
Before use, the
Connect
must be paired with at least one Bluetooth
headphone or other Bluetooth audio receiver.
Make sure your Bluetooth headphone or other device is turned off and
within 1 meter (3 feet) of
Connect
and put it in pairing mode. With most
headphones this is done by pressing and holding the Power/Multifunction
button until the status indicator lights (typically red and blue) flash in an
alternating pattern. If you are unsure of how to activate pairing mode,
consult the user manual of your headphone/device.
Once the headphone is in pairing mode, press pairing button “A” located on
the right side of the
Connect
. A blue light will blink rapidly on the top of the
unit to indicate that the
Connect
is ready to pair. It will pair automatically with
any headphone or other Bluetooth receiver that is also in pairing mode and
located within 1 meter (3 feet). The
Connect
and headphone have to be in
pairing mode simultaneously in order to pair.
The
Connect
will remain in pairing mode for 30 seconds or until successfully
paired. Once paired, the blue light will blink several times and turn solid Blue.
Note:
The above procedure creates a pairing in slot A. To pair a single
headphone in slot B, simply use pairing button “B” instead. To pair two
headphones simultaneously, follow the instructions in the next section.
continue to next page
