BP5BB5LR_UMEN_V05-20170703
10
Make your device Bluetooth-discoverable by pressing the
Start and the Event button simultaneously for longer than 3
seconds, and then release them. The LCD displays the PC--
marking, indicating the recorder is discoverable. The recorders
remain discoverable for a minute then switches back to
standby mode. If a recorder switches back to standby mode,
make it discoverable again.
If there is a moving torch on the screen, the PC searches for
Bluetooth devices. Should a recorder switch back to standby mode due to a
timeout, make it discoverable again then click on the
Add
button.
After the search the found devices are listed.
The name of the recorder in case of BlueBP-05
is BB5_
xxxx,
where
xxxx
is the last four digits
of the serial number found on the back of the
recorder. After selecting the appropriate
recorder, the
OK
button becomes active, click
on it.
As authentication key (PIN) enter the last four
digits of the serial number. After entering the
PIN, click on the
Finish
button. Wait until the
system installs and configures the new Bluetooth device. By clicking on the
Test
button you can check the communication. Make the recorder discoverable before
the test as described above.
4. Program the monitor
4.1 Start programming
CardioVisions (Home screen): select your
device type and click programming.
EasyABPM: Device/New examination
4.2 Enter new patient data or select patient from the database.
4.3 Create a monitoring plan adjusted to the patient’s daily routine by filling out the
parameters for the new study.
