Medisana 88926, Instruction Manual

Page: 11 / 26

10
3 Operating
GB
3.2
Operation • Switch on the device by pressing On/Off button . The power LED
illuminates.
• The buttons , , and control the neck massage. You may
adjust the position and the rotation direction of the both massage
heads. The LEDs next to the buttons and indicate, which ro-
tating direction is active.
• The buttons , , , , and allow a Shiatsu- or tapping
massage for the back area. With the button you may activate a
spot massage (only with tapping massage).
• When the “Upper Back” massage button is pressed, the LED
next to the button illuminates and the Shiatsu massage heads
move from the “Park” position at the base of the backrest, up to the
shoulder area, massaging the back in a circular motion whilst doing
so. Once the uppermost position has been reached, the direction of
rotation of the massaging heads is reversed. The heads then travel
down to the centre of the back. Once the heads reach this point, the
direction of rotation is reversed again and then travel up the back
again. If you press button during the massage, this function is
switched off and the massage heads remain stationary in their cur-
rent position.
• If you press the “Lower Back” massage button , the LED next to
the button illuminates. The Shiatsu massage heads travel up and
down the lower half of the back in a circular motion. The reversal of
the direction of rotation takes place when the respective end posi-
tions are reached. Pressing button during the massage, switches
off this function and the massage heads remain stationary in their
current position.
• If you press the “Full Back” massage button the function proce-
dure is similar to pressing buttons and , except that it is for the
entire back.
• To activate a tapping massage for the selected back area, press
the button . By repeatedly pressing this button, you can change
the tapping massage mode (mode 1 = constant massage, mode 2
= massage with pauses, mode 3 = alternating mode 1 and mode 2
with change of moving direction). If mode 3 is active and you press
the button again, the tapping massage will be switched off.
• The button (level) controls the intensity of the tapping massage.
After switching on the tapping massage the LED “ 1 ” next to the but-
ton lights up ( 1 = low intensity). A press on the button increases
the intensity ( 2 = medium intensity). A second press on the button
increases the intensity again ( 3 = high intensity). After button is
pressed a third time, the tapping massage intensity is set back to
intensity 1 .
• During the tapping massage, press button to activate spot mas-
sage.