Connecting the antenna
Your smart TV processes different antenna signals.
You can input the following image signals to the television through the socket labelled
ANT.
9
:
• Via analogue cable/an analogue house aerial
• Via a DVB-T2/ DVB-T
1
antenna or
• Via a DVB-C
1
connection (digital cable connection)
− Insert the antenna cable either from the house aerial/analogue cable connection, a DVB-T antenna or the
DVB-C connection in the antenna socket on the Smart TV.
To receive encrypted/subscription channels you will need to use a CI module (Conditional Access
Module) and an appropriate card. Insert a CI module (available in specialist shops) in the slot provided
for this purpose on the left-hand side of the device (
COMMON INTERFACE
4
). You can then insert your
provider’s card in the CI module.
Connecting the power supply
− Connect the mains plug on the device to an easily accessible 220 to 240 V ~ 50 Hz mains socket. The socket
must always be easily accessible.
Switching the smart TV on and off
− The device will be in standby mode as soon as you have connected the mains plug to the mains socket.
− To switch the device on from standby mode, press
• on the remote control: the standby/on button, one of the number buttons or one of the
P
/
buttons;
• on the device:
STANDBY
2
switch
− Switch the device to standby mode using the standby/on button on the remote control or by pressing
STANDBY
on the device. The device continues to use power even when switched off (see also the relevant
power consumption in standby mode in the “Product data sheet” section on page 67).
If the device is not receiving an input signal, it will automatically switch to standby mode after three
minutes. A countdown timer will be displayed on the screen until this time. This function is not available
for all sources.
Using the multimedia connections
NOTICE!
Risk of damage!
Incorrect operation can cause damage to the equipment used.
− Before wiring and fi rst use, you must also read the operating instructions of the devices you
are connecting. Take care to ensure that all devices are switched off during wiring.
NOTICE!
Risk of damage!
If plugs and sockets are connected incorrectly it can cause damage to the contacts.
− Take care to ensure that the plugs and corresponding sockets fi t together precisely in order to
avoid any damage to the contacts. Due to the arrangement of the contacts, many plugs will
only fi t into the socket in one position.
1
This service must be available in your region.
21
Getting started
