Preparation for Starting-Up
To operate your notebook safety and ensure a long service life, you should read the
“Operational Safety” chapter at the beginning of this manual. All operating software
is already fully preinstalled on the notebook so there is no need for you to install any
more drivers and you can get started right away.
− Connect the supplied AC adapter to the notebook. Next, connect the power cable
to the adapter and then plug it into a power outlet.
− Always hold the display fi rmly by the middle when folding it back, adjusting the
position and closing it. Failure to do so may damage the display. Never use force
to open the display.
− Open up the display to the desired position using your thumb and forefi nger.
When fi rst operating your notebook please ensure that the battery is
inserted and the AC adapter is connected.
− Switch the notebook on by pressing the on/off button
12
. The notebook will
now start and run through various steps.
The operating system is loaded from the tablet’s read-only memory. The loading
process takes a little longer during the initial setup. Once all the necessary data has
been entered, the operating system will be set up. The operating system is fully
loaded once the Windows® start-up screen appears.
The initial installation may take a few minutes. Do not unplug the
notebook from the power source or switch it off during the initial
installation. This may adversely affect the installation. Do not switch off the
notebook until after the installation has been completed successfully and
the startup screen appears.
Power Supply
On/Off Button
− Open the notebook and hold the on/off button
12
down briefl y to switch the
notebook on or off.
Regardless of the operating system, the notebook will switch off if the switch is held
down for longer than 4 seconds continuously.
Preparation for Starting-Up
22
