English
5
DE
EN
FR
ES
DK
NL
Repair
Leave the repair of your TFT monitor exclusively to qualified specialist personnel.
Please contact our authorised
Service Partners
exclusively in the case of a necessary repair.
Caution! Pay attention to the surrounding temperature!
The TFT monitor can be operated at a surrounding temperature from 0° C to +35° C and at a relative
ambient moisture level of < 80% (non-condensing).
The TFT monitor can be stored at -20° C to +60° C when it has been turned off.
Danger! Pay attention to the following:
Wait to bring the device into operation until it has reached the surrounding temperature,
after the TFT monitor has been transported.
Moisture, which can cause an
electrical short-circuit
, can form within the TFT monitor in
the case of wide
variations in
temperature or moisture
.
Warning! Pay attention to safety during the connection!
Power supply
Please pay attention:
Parts of the device will be subject to voltage, even if the mains switch has
been switched off.
Pull the mains plug from the socket
, to interrupt the power supply to your TFT
monitor or to release the device from voltage completely.
Only operate the TFT monitor at an earthed socket with
100-240V~, 50/60 Hz.
Ask your energy supplier if
you are not sure about the power supply at the set-up location.
We recommend the use of
protection against excess voltage
for additional safety, in order to protect your
TFT monitor against damage because of
voltage peaks
or
electrical
flashes
on the mains network.
Pull the power pack from the socket, to interrupt the electricity supply to your device. Always hold the
power pack firmly when pulling out the cable. Never pull the line.
Do not cover the power pack, in order to avoid damage because of undue heating.
Do not use the power pack any longer if the casing or the supply line to the device is damaged. Replace it
with a power pack of the same type.
Use the power pack supplied with the device exclusively (Model: FSP, FSP 036-DGAA1).
The
socket
must be located close to the TFT monitor and be
easily accessible
.
Lay the cable so that no-one can tread on it or trip over it.
Do not place
any objects on the
cable, because it could be damaged otherwise.
Please pay attention to the fact that the standby switch does not separate the device completely from mains
electricity. The device will consume electricity in standby operation apart from this. Pull the mains plug out
of the mains socket to separate the device from the network completely.
