CHAPTER 3
AWARD
®
BIOS SETUP
3-21
Throttle Duty Cycle
This option will determine how much power will be used by the
CPU , if the system goes into suspend mode.
PCI/VGA Act-Monitor
During Enabled, if there’s no activity in the monitor screen, the
system will go into Power Saving Mode. During Disabled, the system will
go into Power Saving Mode, whether there is activity in the monitor screen
or not. The settings are Disabled and Enabled.
Soft-Off by PWR-BTTN
The settings are Delay 4 sec or Instant-off. During Delay 4 sec, if
you push the switch once, the system goes into suspend mode. If you push
it more than 4 seconds, the system will be turned off. During instant-off, the
system will turn off once you push the switch.
CPUFAN Off in Suspend
During Enabled, if the system goes into suspend mode, the CPU
fan will stop. During Disabled, if the system goes into suspend mode, the
CPU fan will resume.
PowerOn by Ring
During Disabled, the system will ignore any incoming call from the
modem. During Enabled, the system will boot up if there’s an incoming call
from the modem.
Note: If you have change the setting, you must let the system boot up until
it goes to the operating system, before this function will work.
Please refer to JMDM1 (page 2-26) for details.
Power Status LED
This item determines which state the Power LED will use. The
settings are Blink, Dual color, and Single color. During blink, the power LED
will blink when the system enters the suspend mode. When the mode is in
Dual Color, the power LED will change its color. Choose the single color
and the power LED will always remain lit.
