32
Setting up the Wonderseat
.
.
Head Support
Height-Two Methods of Adjustment
1) Stem Adjustment
2) Plate Adjustment
E
Undo clamp handle
(B)
to raise or lower the head support using the
stem
(A)
adjustment. Once the required position is achieved then fully
re-tighten clamp.
Note, at the lowest backrest position the clamp handle may be
prevented from fully turning because of insufficient clearance with
the Bingo-OT seat unit. If this occurs tighten the handle as much as
possible then push button
(D)
and pull handle
(C)
which allows the
handle to slip anticlockwise without loosening. Push handle back in
for further tightening.
WARNING
1) Do not adjust whilst the child is seated in the SPEX
Wonderseat
A
B
Further head support height can be achieved by adjusting the position
of the ball mount
(F)
.
Unzip the cover and fully undo the 4 head support mount screws
(E).
Lift the head support plate to align with next set of screws for 25 mm
of height increase or the lowest set of screws for 50 mm of height
adjustment. Replace and fully re-tighten the screws.
WARNING
At max head
support height the
plastic bung will
be below clamp.
Do not raise any
higher.
F
FIG 6
C
D
Summary of Contents for Spex Wonderseat
Page 2: ......
