Customer Service 1-888-707-1880
Dyaco Canada Inc. 2015
Email:
29
STEP 4: CONSOLE MAST, BRAKE LEVER AND HANDLE BAR ASSEMBLY
1. Locate the console mast cover (31) and route the computer and hand pulse cables (266, 269,
272) and the brake lever & cable (246) through the cover. Temporarily place the cover down on
the main body of the bike. Do not snap the cover in place yet.
2. Unravel the computer and hand pulse cables (266, 269, 272) and snake them through the
Console Mast (2) until the cables exit the top opening of the console mast. Be sure the brake
cable (133) is in the groove of the cover when installing the mast during the next step.
3. Holding the console mast in one hand, and gently keeping tension on the cables at the top of
the mast with the other, install the Console Mast (2) into the Main Frame receiving tube under
the cover (31). Keeping tension on the cables will ensure the wires don’t get caught between
the mast and receiving tube. Do not bolt the mast in place at this time
4. Install the brake lever assembly (246) on the mast with the two 6mm Phillips screws (98). Install
the covers (275) with the four 4mm screws (187). The top screws need to be tightened with the
short screw driver.
5. Slide the mast cover (31) up the mast and bolt the mast in place with six 5/16” x 5/8” Hex Head
bolts (68), four 5/16” Flat Washers (76) on the side bolts, and two 5/16” Curved Washers (83)
on the front bolts. Slide the cover down and snap in place on the main body.
6. Assemble the handle bar to the mast with two 5/16” x 5/8” bolts (68), two 5/16” split washers
(82) and two 5/16” flat washers (76).
