5640.A
4
Set-up Instructions
1.
Remove the TEMP 2
from the shipping box; check before operating to ensure that all of the
packaging material and manuals are removed from the cabinet.
2.
Locate The Documentor
and remove it from the shipping box. Attach The Documentor
to
the TEMP 2
following the instructions below.
3.
Remove the 4 screws in the top of the TEMP 2
. Align the four holes in the TEMP 2
Time/Clock Mounting Bracket and secure using these 4 screws.
4.
Remove the 3 screws in the back of The Documentor
. Attach The Documentor
to the
mounting bracket using these 3 screws.
5.
Plug the Documentor
into the Hospital Grade Receptacle located on the back of the TEMP
2
.
6.
Move the TEMP 2
to the desired location, check that power switch is off and plug the
power cord into an approved outlet.
Documentor
Instructions
1)
Prior to loading the cabinet with bags, use the Documentor
to label the bags with a future
date that follows the manufacturer’s recommendation for the length of time a bag is to be
warmed.
“Future Date Label”
To create a future date label: (See the Documentor
Resetting Instructions for adjusting the
clock date)
i)
Hold the Label sheet face up.
ii)
Line up the arrow on the Documentor
under the words “Remove Fluid By:” on the
label
iii)
Push the label sheet towards the arrow until the Documentor
is activated.
iv)
Place a label on each IV bag for documentation and compliance purposes.
2)
Load the labeled bags of solution into the TEMP 2
®
through the door.