Mediana YM6000, Service Manual

Page: 25 / 100

Performance Verification 19
YM6000 Service Manual
Factory Defaults Adult Pediatric Neonatal
RESP Low Alarm Limits 8 BPM 8 BPM 30 BPM
EtCO
2
High Alarm Limits 80 mmHg 80 mmHg 80 mmHg
EtCO
2
Low Alarm Limits 0 mmHg 0 mmHg 0 mmHg
InCO
2
High Alarm Limits 20 mmHg 20 mmHg 20 mmHg
InCO
2
Low Alarm Limits 0 mmHg 0 mmHg 0 mmHg
TEMP1, 2 High Alarm Limits 39.0
°C
(102.2
°F
) 39.0
°C
(102.2
°F
) 39.0
°C
(102.2
°F
)
TEMP1, 2 Low Alarm Limits 36.0
°C
(96.8
°F
) 36.0
°C
(96.8
°F
) 36.0
°C
(96.8
°F
)
1. Turn on the monitor at the factory default settings.
2. Select Alarm limits icon to display Alarm limits menu .
3. Verify that alarm limits are set to as shown in Table 2.
4. Change Patient mode from Adult to Pediatric or Neonatal, then verify that alarm
limits are set to as shown in Table 2.
5. Change alarm limit value via Alarm limits menu .
6. Save the current changed alarm limit values as a power on default setting via the
service menu (see Service Menu and Factory Defaults section). Turn off the monitor.
7. Press Power button to turn on the monitor.
8. Verify alarm limits are set to the current changed alarm limit values.
Printer Test (Option)
If Printer option is installed in the monitor, the following test procedures will verify the
printer performance.
1. Connect the monitor to an AC power source.
2. Press Power button to turn on the monitor.
3. Connect all necessary simulators to the monitor.
4. Select Setup icon on the screen to display Setup menu .
5. Test #1: 20 sec printing
a. Set Wave record time to 20 sec via Setup menu .
b. Press Print button when all the parameter signals display normally.
c. Verify that the parameter values and waveforms are printed out for 20
seconds.
6. Test #2: Continuous printing
a. Set Wave record time to Continuous via Setup menu .
b. Press Print button when all the parameter signals display normally.
c. Verify the parameter values and waveforms are printed out
continuously.
d. Verify printing stops with pressing Print button again.