5
DB25 male connector:
1:
X input +
2:
Y input +
5: Red
+
6: Green
+
7: Blue
+
14:
X input -
15:
Y input -
18:
Red
–
19:
Green
–
20:
Blue
-
25:
Ground
All signals are available also on the DB25 female connector, for wiring the control signals to
a second projector.
Adjusting projection size
Just next to the ILDA connector, you will find projection size adjustments, and mirror
switches, to mirror each projection axis in case of rear projection, or upside down mounting.
The functions are self explaining.
Connecting to power
The internal power supplies are multi voltage switching power supplies, and will adapt to
almost any power source on the planet. Use a standard power cord. No switching is necessary.
For US countries, or other countries with low AC voltage, a different fuse might be necessary.
In this case, replace the 2A fuse with a 4A type.
Scanfail safety circuit
All AttaXX projectors are equipped with a fast scanfail safety device. It monitors the galvo
movements, and shuts off laser beams within a very short time, if a scanfail is detected, or if
both galvos stand still without movement. The electronic shutdown takes less than 25ms.
Please note, that it cannot protect incorrect or dangerous show programming!
LANnetwork upgrade option
If you ordered the optional LAN network upgrade, your AttaXX is equipped with the latest
network laser control technology, to avoid any fragile analog control cables. The entire laser
projector control is done via regular CAT5-CAT6 cables. From Mamba 2.0, there is an
appropriate driver included in the software. See the attached addendum for more information.
