6.
1.
2.
Important: Make sure to reconfigure at least the user's authentication and firewall rules (if applicable), otherwise it may leave the unit unsecure.
Results
The unit will be reachable either on the new configured static IP address or on the DHCP .
Top
Factory Reset
The Factory reset reverts the Mediatrix unit back to its default factory settings.
It deletes the persistent configuration parameters of the unit, including:
User files stored in the File service
Certificates, except for factory installed ones
Log files of the File service
The Factory reset should be performed with the Mediatrix unit connected to a network with access to a DHCP server. If the unit cannot find a DHCP
server, it will sent requests indefinitely. A Factory Reset can be triggered either:
Directly on the unit. Refer to
.
Via the web interface of the Mediatrix unit (
/
).
Management Firmware Upgrade
Via the Command Line Interface of the Mediatrix unit by using the
parameter.
fpu.defaultsetting
Top
Performing a Factory Reset
Context
The Factory reset alters any persistent configuration data of the Mediatrix unit.
Steps
Insert a small, unbent paper clip into the hole of the
button, located on the Mediatrix unit.
Reset/Default
Note: Do not release the
button before the LEDs stop blinking and are steadily ON. This can last from 12 to 16 seconds. If you
Reset/Default
leave the inserted pin longer, no action will be taken which is useful if you accidentally pushed the button and do not need any action to be
applied.
Release the paper clip.
Result
All configuration parameters are reset to their default value. The unit can then be contacted via its WAN interface DHCP-provided IP address (ETH1 or
WAN on the 4102S), or via its LAN interface default IP address 192.168.0.10 (ETH2 or LAN on the 4102S).
Top
Standards Compliance and Disclaimers
Supported Standards
Note: The standards compliance of the Mediatrix units are printed on the same sticker as the product serial number. Refer to
.
Category
Specification
Agency approvals and other compliances
Anatel
European Union
CE mark (Declaration of Conformity)
UL mark
FCC
NOM, IFETEL
Safety standards
UL 60950-1, 2nd Edition, 2014-10-14
CAN/CSA-C22.2 No. 60950-1-07 2nd Edition, 2014-10
IEC 60950-1: 2005 (2nd Edition); Am1: 2009 + Am2: 2012 with all national deviations
EN 60950-1: 2006 + A1: 2010 + A11: 2009 + A12: 2011 + A2: 2013
NOM-019-SCFI-1998
Emissions
EN61000-3-2: 2014
EN61000-3-3: 2013
FCC part 15 (2016) subpart B, class B
EN55032 (2015), class B
ICES-003 (2016), class B
Immunity
EN55035: 2017
Top
Federal Communications Commission (FCC) Disclaimer
This device complies with Part 15 of the FCC Rules. Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
