medi protect.4 evo, Instructions For Use Manual, Page: 5 / 30

English
on a level with the top edge of the kneecap.
Make sure that the brace is not twisted on
your leg.
• First fasten the lower front calf strap (strap
#1), then the upper back thigh strap (#2). Keep
your knee in a flexed position and push both
joints towards the back of the leg.
•
Now fasten the lower back thigh strap (#3).
Make sure that you do not have the hinge
joints positioned in front of the midline of the
leg.
• Now fasten the upper front calf strap (#4).
Then the upper back calf strap (#5), and finally
the front thigh strap (#6).
• Bend your knee slightly a few times and
refasten the straps again in the order
described above to prevent the brace slipping.
Care instructions
You can wash the inner and condyles upholstery
by hand using cold water and a mild soap,
preferably a medi clean detergent. Do not
bleach. Air dry. Do not iron. Do not dry clean.
When used normally the brace is maintenance-
free. However, after using the brace in water,
the hinges can be lubricated using Teflon™
spray. Check regularly that the joint screws are
secure, tighten them if necessary.
    
Storage instructions
Keep the brace in a cool, dry place and do not
expose to direct sunlight.
What can I do if the brace slips?
• Check that the brace is fitted properly. The
centre of the brace joints should be level with
the upper border of the kneecap.
• Make sure that the back thigh strap (#5) is
above the belly of the calf muscle
•
Do not wear the brace over clothes.
Material composition
Avional, Velours, Polyester, PU foam
Statutory Defects Liability / Contractual
Guarantee
Consistent with legal guidelines.
Disposal
The product can be disposed of in the domestic
waste.
E011303_AAL_protect.4_evo.indd 5 04.02.14 15:21