15
8.
The LCD display will flash the
information that was entered into the
warmer and display the completion
time.
9.
Confirm that the information is correct
and press the
start
button to begin
warming.
Note:
If the information is incorrect, press the
stop
button and
repeat programming steps above.
10.
There are two timers
located on the display.
The lower left display
will show the total cycle
time and will count
down to zero. The upper
left display shows total
elapsed time the milk
has been in the warmer.
11.
If the lid is opened during the warming
cycle, the warmer will go into a Pause
Mode for 60 seconds. The visual indicator
on the front of the unit will flash yellow.
Note:
Open the lid to activate Pause Mode while using a syringe.
If the syringe or container is placed back in the unit, close the lid
and press the
start
button. The cycle will continue until the of the
session is complete.
Note:
If 60 seconds is exceeded, the unit will stop and reset.
cycle time
elapsed time
10
11
8
9
Summary of Contents for Waterless Milk Warmer
Page 79: ...77 ...