Manual Cycle Mode
Pressing the
Up
key will drive the crosshead upwards at the
speed indicated by the front panel display. Pressing the
Down
key will drive the crosshead downwards at the speed indicated
by the front panel display. While the crosshead is moving, the
display will show the current speed set with the other direction
hidden. The crosshead will continue to move in the appropriate
direction all the time the
Up/Down
key is pressed. Releasing
the
Up/Down
key will stop crosshead movement. When the
crosshead is moving up or down if an optical limit switch is
encountered, the crosshead will stop. The current speed the
crosshead is travelling at may be changed using the dial.
When the stand stops the speed will revert to the set speed.
Single Cycle Mode
Pressing the
Up
key will drive the crosshead upwards at the
speed indicated by the front panel display. Pressing the
Down
key will drive the crosshead downwards at the speed indicated
by the front panel display. While the crosshead is moving the
display will show the current speed with the other direction
hidden. When the
Up/Down
key is released, the crosshead will
continue to move until an optical limit switch is encountered, at
which point the crosshead will stop before travelling in the
opposite direction for a single cycle. In single or continuous
cycle mode when any key is pressed after the release, the stand
will stop.
Continuous Cycle Mode
In this mode the stand will continue to cycle between limit
switches or between load limits, while counting the number of
cycles. When the position of the other optical limit switch (or
load limit) is reached, the crosshead will stop and reverse.
Note
that during the cycle, pressing any key should stop the
crosshead. After 999 cycles, the counter is reset to zero and the
stand will continue to cycle. In any mode, the current speed the
stand is travelling at may be changed using the dial. This speed
will revert to the set speed on next step of cycle or stop.
page 14
Manual
Cycle Mode
Single
Cycle Mode
Note:
Do not push or pull the
limit switches with your hand.
Pressing any key will stop the
stand moving.
Continuous
Cycle Mode
Note:
A Mecmesin AFG gauge
and cable is required to cycle
between load limits.
