Page 86
65-J Desel - Servce & Parts Manual
February 2021
Secton 18 - Mechancal Components
Install the Swing Bearing with the painted teeth placed
on the same side of the chassis as the Rotation Lock.
Due to the placement of the mounting holes in the
Chassis, the teeth will be slightly forward from straight
sideways.
ART_4952
Painted Teeth
Rotation Lock
Use an alternating criss-cross pattern to tighten the bolts securing
the Swing
Bearing to the chassis. Tighten the bolts in three stages.
Tighten to 50 lb/ft (68 Nm) on the first pass.
Tighten to 100 lb/ft (136 Nm) on the second pass.
Tighten to 180 lb/ft (244 Nm) on the first pass.
Use the same pattern and stages later when securing the turntable
to the Swing Bearing.
ART_5007
2
1
3
5
7
4
6
8
10
12
14
16
18
20
9
11
13
15
17
19
Set the Swing Drive in place after the Turntable
is bolted down to the Swing Bearing. Rotate the
Turntable slightly so that the Swing Drive engages the
painted teeth on the gear.
The Swing Drive has three slotted mounting holes and
one round hole to allow gear backlash adjustment.
Arrange as shown, with the round hole at the near
right.
ART_4953
Round Hole Here
Swing Drive