“
Lo.PC.t
” error will be displayed when the Enter key is pressed.
4.
Begin weighing. The total quantity and the total weight will be shown.
Note: The limited number of display digits may display rounding in some cases. As such, if you manually divide the
displayed total weight by the displayed piece weight, it may not equal the displayed piece quantity. Despite this, the
displayed piece quantity is correct.
Accumulation Mode
The accumulating function allows storage of weighed piece quantities and the summation of those quantities.
1.
In counting mode, press the Accu key to add the displayed value to the accumulated total.
2.
The indicator will display “
Add
” in the WEIGHT window, the PIECE WEIGHT window will display the times of
accumulation instances, and the COUNT window will display the number of accumulated piece quantity.
Note: To avoid duplicating a value for a same load, the accumulation function requires the original load to be
removed (platform weight to drop below the minimum weight) before a new value can be accumulated.
3.
Press and hold the Accu key for 4 seconds to display the accumulated values. The WEIGHT window will display
“
Add
”, the PIECE WEIGHT window will display the times of accumulation instances, and the COUNT window will
display the accumulated quantity.
4.
To clear accumulated quantities, press and hold the 0/Clear key while the accumulated values are being displayed
NOTE: Powering off the scale will also clear the accumulated values.
NOTE: Accumulated quantities or instances over 999999 will display “
Err01
”.
Check Weighing (Data Compare) Mode
The check weighing or data compare function allows the user to input a pre-set range, and the display will indicate
whether the weighed quantity is within that range, or indicate if it is too high or too low. Example: If a piece count of 100
± 1 piece is desired, a range of 99 to 101 can be set. When the quantity on the platter is within the range, an audible
tone will sound.
1.
From counting mode, press the Hi/Lo key to enter this mode. The WEIGHT window will show the current weight and
the PIECE WEIGHT window will show “
Hi.PCS
” (High limit pieces). The COUNT window will show any previously
stored upper limit.
2.
Use the number keys to input the upper piece quantity limit (hold the 0/Clear key to delete all). Press the Enter key
to confirm or press the ZERO/ON/OFF key to exit this mode without storing the piece quantity.
3.
The WEIGHT window will continue to show the current weight and the PIECE WEIGHT window will show “
Lo.PCS
”
(Lower limit pieces). The COUNT window will show any previously stored lower limit. Use the number keys to input the
lower piece quantity limit (hold the 0/Clear key to delete all). Press the Enter key to confirm or press the
ZERO/ON/OFF key to exit without storing the piece quantity.
4.
Press ZERO/ON/OFF to exit.
Note: Limits will be stored in memory until they are modified according to the above steps.
Note: Limits should be: Upper limit ≥lower limit>0. If the upper limit is less than lower limit or if the upper limit is
set as zero, check weighing is disabled.
5.
To turn check weighing off, follow the above instructions and change the upper limit to zero.
EHC
‐
C
www.measuretek.net
.
5
.